Slab gate valves are comprised of a single gate
Aug 6, 2020 - Aug 7, 2020
11:00 AM - 11:00 AM (Asia/Shanghai)
ca, ca

This event has ended. Please contact organizer for more details.

Report Issues

A gate valve like stainless steel foot valve is really a linear motion valve currently in use to start or stop the flow from the fluid in piping. There can be a gate or wedge type disk which moves perpendicular on the flow which directs the flow to halt or start. In any process plant, the gate valve provides the most common use and therefore are suitable for both above-ground and underground installations. A gate valve is additionally known as a sluice valve. It is very all to easy to open it, one just need to lift the gate out with the path with the fluid. It does not demand a wide surface; they can fit in a very little space over the pipe axis. It requires a 360° surface contact between disk and seat to obtain proper sealing.

A Gate valve is comprised of certain parts that enable it to operate properly. Valve’s body or shell is among the most principal point about this particular valve which may connect inlet and outlet pipes inside a piping system. Some other aspects of a gate valve are as followed. Bonnet, Solid Wedge, Body seats, Stem, Back seat, Gland follower, Gland flange, Stem Nut, Yoke Nut, Handwheel, Hand wheel nut, Stud bolts, Nuts, Bonnet Gasket, Lubricator, Packing. All these parts permit the Gate & sluice valve to operate properly.

Slab gate valves are comprised of a single gate unit which raises and lowers between two seat rings. Due to your fact which the gate slides between seats, slab gate valves are suited to the medium with suspended particles. The sealing surface of slab gate valves is virtually self-positioned and is not damaged with the thermal deformation on the body. Even if the valve is closed inside a cold state, hot elongation with the stem doesn't overload the sealing surface, and slab gate valves without diversion holes undertake and don't high precision within the closing position in the gate. When the valve is fully open, the bore through is smooth and linear, the flow resistance coefficient is minimal, piggable with no pressure loss.

Slab gate valves also provide some disadvantages: if the medium pressure is low, the metal sealing surface would possibly not seal completely, instead, once the medium pressure is way too high, the highly-frequency frequent lowering and raising may make the sealing surface wear excessive when there is no medium or lubrication. Another drawback is the fact a circular gate that moves horizontally with a circular channel controls flow effectively only once it is at 50% on the valve’s closed position.

On additional hand, gate valves belong for the linear motion valve family. Otherwise known as the knife valve or even the slide valve, the gate valve carries a flat or wedge disc that provides for a gate. This gate or disc controls the flow of fluid within the valve. The gate valve is the most suitable used if the linear flow of media with less pressure drop is preferred.

It is really a shut-off valve with throttling capacity. It is intended more for material flow regarding flow regulation. More suited to thicker flow media, the flat disc of gate valves makes it easier to slice through such type of media.

  1. ​ca,
    Calgary, Alberta, Canada


Organiser : joannecheng


Explara uses cookies to enhance your experience. By using our site, you agree to our privacy policy.

Slab gate valves are comprised of a single gate

Ask Organiser

Report spam or issues